On a Simplex Hotspot keying up a non-static Talkgroup will make it auto-static, sort of an extra Static one. The Brandmeister support for Reflectors is to be discontinued Talkgroup 9 will then be spare. This lists the active Talkgroups and allows you to change them. Talkgroups can be set Static using the controls added to the dashboard using the Brandmeister GUI. This network is the most comprehensive, with around 1573 Talkgroups. It only takes one irresponsible operator to chat to people on World Wide 1 to effectively bring down the entire Phoenix repeater base in the UK. The problem is the wider the coverage of a Static Talkgroup the more repeaters you use blocking their use by other people. Once a contact has been established (QSO) you should change Talkgroup (QSY) to one of the many chat or tactical Talkgroups. It is good practice not to ‘rag-chew’ on the calling or primary channels. RAYNET has configurable Statics and remembers the last Talkgroup used as a Dynamic. Phoenix has fixed Statics and User Activated (dynamic) Talkgroups. Talkgroups can be either Static – available all the time, or Dynamic – non-static for a period available after you have used it, or until perhaps you chose another non-static one.īrandmeister has configurable Statics, as well as dynamic and pseudo-statics. The three different Networks discussed in this document all act differently in respect to keeping Talkgroups active on Hotspots: For instance, listening to TG840 on Phoenix will necessitate keying it up at least every 15 minutes this is different behaviour to RF repeaters that have defined Static Talkgroups (including 840 in East Anglia). This means that Talkgroups may be timed out by the Network. Except things are never that straight forward on DMR – it depends which Network you are on! The Hotspot is treated like a Repeater by the Networks, particularly by Phoenix. Note – you may need to key it up before you hear anything.Ĭhanging channels to a different Talkgroup and keying that up will switch to that one instead. Then simply keying up the Channel will activate the Talkgroup. The Network needs to be enabled on your Hotspot and there needs to be a Channel in your radio set to use the Hotspot and with the appropriate Talkgroup or Digital Contact ID, Group Call set. In order to use a particular Talkgroup you need to do two things. If you only want to use one Network then select that as DMR Master otherwise, you will have to use DMRGateway as the Master. Phoenix is more UK centric but has limited Talkgroup controls. Of the two UK Networks, Brandmeister offers the most Talkgroups and, with the Brandmeister API installed, the most control. However, depending on which Network you are on, the choice may make all the difference to your DMR experience. The next issue is which Talkgroups or Reflectors do you use? Obviously, this will be to some extent a personal decision. Users select to listen or transmit on a talkgroup and will then hear traffic for that talkgroup number. A talkgroup is a number like a phone number, this is how your traffic is routed around the DMR network.
0 Comments
Leave a Reply. |